Need a correct phone jack!

Just bought a wrong cable from online shop again .

I thought it is RJ11 because it is little bit smaller than the normal RJ12 one but I was wrong.
People call it RJ9, RJ10, RJ22 but not RJ11!


0x80070040 Error Code during SCCM OSD.

Got below errors when doing the OSD:

Connecting to "\\xxxx0000.abc.COM\SMSPKGF$\pkg0009"
Successfully connected to "\\xxxx0000.abc.COM\SMSPKGF$\pkg0009"
Found boot image \\xxxx0000.abc.COM\SMSPKGF$\pkg0009\Boot.pkg0009.wim
Copying boot image locally...
::CopyFileEx( sImageSourcePath, sImageDestPath, CopyProgressRoutine, pProgressData, &pProgressData->bCancel, 0), HRESULT=80070040 (e:\nts_sms_fre\sms\framework\tscore\bootimage.cpp,635)
Unable to copy boot image \\xxxx0000.abc.COM\SMSPKGF$\pkg0009\Boot.pkg0009.wim locally.
The specified network name is no longer available. (Error: 80070040; Source: Windows)
 Failed to stage WinPE. Code(0x80070040)

Solution 1 from one of my deployments
Problem fixed after configuring "port fast" on my CISCO switch as it caused delay of DHCP IP address.

Also, it won't hurt if you check the server network settings to ensure teaming configuration is done properly.
Solution 2 from one of my deployments:
Figured out the problem was due to wrong settings on my SCCM server.
The site where I was building the machine is a secondary site and it has incorrect site boundaries configured hence the build process always trying to connect the remote DP to download packages and that caused the error.

Solution 3 from someone:
Unplugged the laptop from netgear hub and plugged it directly into our wall jack and it worked fine.

Solution 4 from someone:
I've seen on some occasions  that the network actually loses connection or fails to get an IP address. usually something to do with Spanning Tree or duplex settings on the switch. I've gotten around this by plugging the system into a switch port that forces duplex (like an IP phone for example).


部署 Windows Vista 需要了解的十大事项

部署 Windows Vista 需要了解的十大事项